SAFL

Spigot saddle with flange outlet, SDR 11

Spigot saddle with flange outlet SAFL SDR 11

Gas and water
Working pressure: MOP (gas) 10 bar, PFA (water) 16 bar
Material: PE 100
Saddle component with clamp and flange
Tapping under pressure possible
Safety technology
DVGW test mark: DV-8606AU2249

Note:

For pressure-free tapping, we recommend our FWAB drilling device.

For tapping under pressure, we recommend the drilling tool from Hütz & Baumgarten (www.huetz-baumgarten.de).

Note the screw tightening torques after specifying the seal manufacturer and/or DVS and the utilisation of a GST seal.

If required, please contact our hotline: +49 621 486-2325.

Go back Data sheet

PE 100 SDR 11

Maximum permissible working pressure 16 bar (water) / 10 bar (gas)

Reference	d₁	B	b	D	dk	H	H	L	Drilling Ø d_a	Weight kg	BX	PU
616016	110	165	25	204	16,5	296	296	190	65	3,710	3	54
616017	125	185	25	204	16,5	311	311	205	65	3,940	2	36
616018	160	217	25	204	16,5	346	346	245	65	4,320	2	36
616019	180	241	25	204	16,5	366	366	285	65	4,610	2	36
616020	225	286	25	204	16,5	411	411	284	65	4,720	2	16
616022	160	217	27	224	16,5	346	346	245	84	5,270	2	36
616024	225	286	27	224	16,5	411	411	284	84	5,640	2	16

FRIALEN safety fittings can be fused with pipes with SDR levels 11 to 17.6. Other levels of SDR can be processed on request. Please note the mandatory labels directly on the product. DVGW test mark issued: DV-8606AU2249

Areas of Application

The FRIALEN Spigot Saddle with Flange Outlet SAFL is used for the integration of flange valves and hydrants up to PN 16.

Assembly Instructions

The saddle of the SAFL is mounted and fused onto the HD-PE mains. Drilling into the HD-PE mains can take place

without pressure in the mains
under operating pressure on application of a gate-valve on the flange side

using standard drill equipment. We recommend Hütz + Baumgarten.

The fusion of the saddle piece with the HD-PE mains takes place using FRIALEN-fusion –leakproof and longitudinally strong. Saddle and HD-PE mains are prepared according to the general installation instructions (see Assembly Instructions for “FRIALEN-Safety Fittings for house connections and distribution pipes up to d 225”). This involves removing oxide skin.

The flange connection measurements correspond to DIN EN 1092-1. Supplementary washers are required.

All standard profile and flat gaskets can be used. Torques advised by the gasket manufacturer must be observed. We recommend profile gaskets of type G-St.

Good reasons for using the FRIALEN-Spigot Saddle with Flange Outlet SAFL: