Cap, SDR 11

Areas of Application

The FRIALEN-End Caps MV are used to close HD-PE pipe ends.

Also recommended as fused caps (d32 and d40) for the dome of FRIALEN-Pressure Tapping Tees DAA and DAP up to d63.

Assembly Instructions

The fusion of a pipe end or the dome of a FRIALEN-Pressure Tapping Tee with the FRIALEN-End Cap MV takes place using FRIALEN-fusing – leakproof and longitudinally strong.

The fusion area is prepared according to the general installation instructions (see “Assembly Instructions” for “FRIALEN-Safety Fittings for house connections and distribution pipes up to d 225”). This involves removing the oxide skin and cleaning the pipe ends. Next to moulded fittings and accessories it is recommended to install a piece of pipe of 20 - 60 cm length, accordingly to the diameter, so that the pipeline can be continued later on.

Good reasons for using the FRIALEN-End Caps MV:

• Large coupler depth for ease of pipe guiding (no holding clamps required)

• Extra wide fusion zones

• Maximum stability through great wall thickness

• Cold zones at the front side and in the middle of the coupler

• Exposed heating coil for direct heat transmission to the pipe

• Small annular gap for build-up of optimum joining pressure in the fusion zone

• Touch proof electric contacts

• Fusion indicator for visual fusion control

• Durable batch marking

• Individually wrapped for dirt protection

• Additional barcode for tracing back the fitting (Traceability-Coding)